Replacement Method of Main Parts in Use of Drug Stability Test Box
Method of Replacing Main Parts Damaged in Drug Stability Test Box
1. Floating Ball: Open the cap of the water cup and loosen the nut that holds the float ball with an open wrench.
2. Heating tube: Open the sheet metal in the inner air duct of the drug stability test box and loosen the fixed nuts at both ends of the heating tube with an open wrench.
3. Humidifying pipe: Open the cover of the humidifying barrel with an inner hexagonal wrench and turn the heating pipe with a flexible wrench or pipe pliers.
4. Electrical components: According to the instructions, remember to cut off the power supply.
5. Printing paper: Grab the movable tongues on both sides of the printer with your fingers, open the panel cover and remove the old ones first; Grab the movable tongues on both sides of the printer with your fingers; Pull the printer out, grab the two sides of the ribbon with your fingers, and gently push it upward; Then put the new ones on, grab the two sides of the ribbon with your fingers, and put them in place. Pay attention to the ribbon between the axis and the shield. Paper can be packed.
6. Printing paper: Hold the movable tongues on both sides of the printer with your fingers and open the cover of the panel; load the paper axis into the paper roll (pay special attention to the direction of the printing paper), then load it into the printer's paper bin, and fix the two sides of the paper axis in the chute.
1. Floating Ball: Open the cap of the water cup and loosen the nut that holds the float ball with an open wrench.
2. Heating tube: Open the sheet metal in the inner air duct of the drug stability test box and loosen the fixed nuts at both ends of the heating tube with an open wrench.
3. Humidifying pipe: Open the cover of the humidifying barrel with an inner hexagonal wrench and turn the heating pipe with a flexible wrench or pipe pliers.
4. Electrical components: According to the instructions, remember to cut off the power supply.
5. Printing paper: Grab the movable tongues on both sides of the printer with your fingers, open the panel cover and remove the old ones first; Grab the movable tongues on both sides of the printer with your fingers; Pull the printer out, grab the two sides of the ribbon with your fingers, and gently push it upward; Then put the new ones on, grab the two sides of the ribbon with your fingers, and put them in place. Pay attention to the ribbon between the axis and the shield. Paper can be packed.
6. Printing paper: Hold the movable tongues on both sides of the printer with your fingers and open the cover of the panel; load the paper axis into the paper roll (pay special attention to the direction of the printing paper), then load it into the printer's paper bin, and fix the two sides of the paper axis in the chute.
